8" Low-Profile Kit — Over 80"

Description

Two 8 by 3 by 2.8 inch lamp housings on a 4 inch bolt pattern, each carrying 11 red and 2 white LEDs. The left housing faces the kerb with a downward white LED for the plate; the right housing is the plain curb side. Both run the same two-level wiring: brown with white is the low tail / running / clearance level, yellow-green with white is the high stop / brake / turn level, so one lamp covers tail, stop, turn, side marker and plate.

The kit is built for trailers over 80 inches wide and ships with a 25 ft harness on a 4-flat plug, plus a plate bracket and the splice connectors. Wire it once at the rear and the whole back end is covered from one part number.

• Two brightness levels on separate wires — brown for tail, yellow-green for stop/turn
• Left housing carries the plate illuminator, right side is the plain curb side
• 25 ft harness, plate bracket and splice connectors in the box
• IP67 — sealed against rain, dust and road spray

Specification

What ships in the box

• 2 × 8" boxed lamp assemblies
• 1 × 25 ft harness with 4-flat plug
• 1 × license plate bracket
• Splice connectors, butt connectors and screws